Page 1 of 1
x-tenna
Posted: Sun Apr 12, 2009 7:11 pm
by Ranger
Any one tried the new x-tenna from tracker yet? Just wanted to see before ordering one.
Re: x-tenna
Posted: Sun Apr 12, 2009 8:41 pm
by Trueblue
It only works on the Complete model.You know that right ?
Re: x-tenna
Posted: Sun Apr 12, 2009 11:15 pm
by DesertDweller
It uses sma connections on the cable but they make sma to bnc cables, so I am sure you could use this antenna with any unit that accepts a bnc connector.
Re: x-tenna
Posted: Mon Apr 13, 2009 1:28 am
by Trueblue
Nope,thats not the case Alan.I have personally talked with Jen at Tracker about the Antenna and even went in and looked at it when it was in the R&D mode.They told me that the only Tracker model it will work on is the Tracker Complete.The amp on the antenna does not have its own power source.It gets its power from the Tracker and only the complete is built to do that.
Re: x-tenna
Posted: Mon Apr 13, 2009 3:14 am
by DesertDweller
IC, thats only my thoughts just looking at it, did'nt know anything about it till I read this post..........